Get Answers to your Appliance Repair Questions

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   AppliancePartsPros 

Author Topic: jenn air oven  (Read 1598 times)

Offline melie

  • VIP Member
  • Member Since: May 2011
  • Posts: 1
jenn air oven
« on: May 31, 2011, 02:30:49 PM »

I have an F2 error reading on my Jenn Air model #w27100w with a broiler that won't go off even after I shut the breaker off and then turn it back on.  I've seen some discussion on other Jenn Air models with this problem, but not my particular model number.  Any ideas?  Thanks!!

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8804
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: jenn air oven
« Reply #1 on: May 31, 2011, 02:52:24 PM »
F2 Oven over heat defective Relay Board most likely OR a bad sensor.
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL


Jenn-Air self cleaning oven problem

Started by ralphthedog

Replies: 6
Views: 17044
Last post December 13, 2007, 08:15:34 PM
by ralphthedog
How can I find the manual for a Jenn Aire double oven?

Started by Dukes

Replies: 2
Views: 6205
Last post December 16, 2007, 04:40:06 PM
by Dukes
jenn air oven broil switch #704355

Started by jimfish

Replies: 2
Views: 5127
Last post March 14, 2008, 11:28:27 AM
by JWWebster
Maytag (Jenn-Air) Electric Oven electrical problem

Started by gus

Replies: 5
Views: 7309
Last post November 04, 2008, 06:00:43 AM
by Repair-man
30 in Jenn-Air wall oven

Started by blwn31

Replies: 2
Views: 4734
Last post November 20, 2008, 04:41:54 AM
by Repair-man
Jenn-Air Gas Oven not Heating Properly.

Started by TechnicianBrian

Replies: 0
Views: 5985
Last post December 14, 2008, 02:21:32 PM
by TechnicianBrian