Get Answers to your Appliance Repair Questions

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: whirpool gas dryer not heat  (Read 7465 times)

Offline Jos

  • VIP Member
  • Member Since: Feb 2008
  • Posts: 40
Re: whirpool gas dryer not heat
« Reply #10 on: December 27, 2010, 08:38:28 PM »

well finally  fix the dryer, 

after replace coils, check timer, fuse ...   i open the gas valves ( not sure of correct name) the coils are on top,  so i open this unit and clean inside, take out gaskets, springs, and set back again, and works fine at the first start up

thank you all for your support

best regards

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8809
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: whirpool gas dryer not heat
« Reply #11 on: December 27, 2010, 08:42:27 PM »
Glad to help Kimosabe!!!
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL


whirpool gas dryer not heat, Mod:LGQ8000JQ1

Started by Jos

Replies: 2
Views: 1843
Last post April 29, 2014, 10:20:40 PM
by lesguns
IA84600 Inglis dryer doesn't heat

Started by RickT

Replies: 5
Views: 12226
Last post January 16, 2008, 04:02:42 PM
by JWWebster
maytag dryer model # md 3500 (no heat)

Started by #13

Replies: 5
Views: 11610
Last post December 05, 2007, 07:15:02 AM
by apptech
LG gas dryer wont heat

Started by berniet

Replies: 17
Views: 24840
Last post December 03, 2014, 12:15:07 AM
by BillR625
Whirlpool Dryer - Run, but does not heat.

Started by AJ

Replies: 5
Views: 7235
Last post May 30, 2015, 09:07:45 AM
by fairbank56
Creda dryer runs but makes only a little heat

Started by goldstonemr

Replies: 33
Views: 24209
Last post April 27, 2008, 02:56:23 PM
by Penguin45