Get Answers to your Appliance Repair Questions

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Neptune Will Not Go Into Spin  (Read 2329 times)

Offline Jaytag

  • VIP Member
  • Member Since: Jan 2009
  • Posts: 143
Neptune Will Not Go Into Spin
« on: June 19, 2010, 01:41:43 PM »

Neptune wont go into spin, motor whines.  Control Board was replaced 2 yrs ago, is this the motor?  Less than 10 yrs old.

Model MAH3000AWW

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8809
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
« Last Edit: June 19, 2010, 01:46:51 PM by JWWebster »
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline Jaytag

  • VIP Member
  • Member Since: Jan 2009
  • Posts: 143
Re: Neptune Will Not Go Into Spin
« Reply #2 on: June 29, 2010, 11:13:43 AM »
Ok checked out mother board no signs of issue.  What happens actually is that it tries to go into spin but just spins slowly.  Pump is pumping out water, as it is about to ramp up the pump gets louder and then softer and it just doesnt go into high spin.

Offline tazguy25

  • VIP Member
  • Member Since: Jul 2010
  • Posts: 2
Re: Neptune Will Not Go Into Spin
« Reply #3 on: July 01, 2010, 08:40:05 PM »
Sounds Like a Spin enable switch to me ;) You can by pass it with a paperclip from one of the red 24v wires & I believe the yellow wire on P3 while in the spin cycle(Or at the switch if you want to deal with getting to it).... Double check on the schematic that its the wire that goes to the spin enable switch though...Been a while since I worked on those on a daily basis.


Maytag Neptune MAH4000AWW - No Spin.

Started by larry

Replies: 39
Views: 83497
Last post February 21, 2011, 01:22:14 PM
by bwhelan
Maytag Neptune Washer - No Spin

Started by AJ

Replies: 6
Views: 10679
Last post February 20, 2008, 12:41:13 PM
by AJ
Maytag Neptune Mah4000aww will not go through cycles or spin...

Started by Mudd222

Replies: 11
Views: 10883
Last post April 23, 2013, 11:14:30 AM
by def
Maytag Neptune Very Noisy During Spin

Started by TechnicianBrian

Replies: 0
Views: 4701
Last post April 24, 2008, 10:14:55 PM
by TechnicianBrian
Neptune top load, won't spin

Started by fanbelt

Replies: 4
Views: 4541
Last post April 27, 2008, 05:21:52 PM
by fanbelt
Maytag Neptune Washer - LR on display and no spin

Started by AJ

Replies: 0
Views: 6481
Last post May 05, 2008, 07:00:37 PM
by AJ