So my parts have arrived from Appliance Junk right on time, and it's time for the repair. I have put the new drum bearing on. That wasn't too hard.
I have printed out a diagram of the dryer parts and how they go back together, but I'm still having some challenges. My questions start with with part #516 , the nut sheet metal, and part #515, the ground strap assembly. These parts kind of fell out of "nowhere" when I removed the heater assembly during disassembly. So I never saw how they originally fit together. How do they fit together?
Does the little black padded part of the ground strap assembly rest against the back wall of the dryer? Or does it rest against the the back of the heater assembly?
Is the padded part suppose to be sticky so it stays in place?
How does the shaft bracket assembly match up with the ground strap assembly and the nut sheet metal?
Does the pointed part of the shaft bracket assembly push through the hole in the ground strap assembly? Or does it press against a different part of the shaft bracket assembly?
Does the nut sheet metal go on the other side of the hole and protect the back of the dryer from being drilled out by the point on the shaft bracket assembly?
Does the hollow part of the nut sheet metal face the back of the dryer or the ground stralp assembly?
What holds the nut sheet metal in place?
Does anyone have a detailed diagram of what this should look like?
A million thanks to anyone who can help.