Forum Index > Dishwasher Repair

Whirlpool Dishwasher Flamed out K2 relay on Whirlpool control board

<< < (2/3) > >>

Thanks again for the helpful replies.

Does anyone know of any guides/manuals that describe how to replace the thermostat and thermistor? I don't even know where they're located.

Thanks again for all the help,


Your post above says you already checked these parts and have readings on the parts.
Did you check them or did someone else check them?

His post says he checked them from the console, which is the correct way to do it. The thermostats are located under the tub pressed against the bottom. Remove the lower panel to see and replace them.

My bad.
I apologize for the misinterpretation.
Merry Christmas to all and forgive JT51.

Not a problem, I appreciate all of the attention everyone has given this.

I didn't have a chance to look for the thermostat and thermistor yesterday. Can they be replaced by getting access to them through the kick plate or do I have to pull the dishwasher out?

Thanks again to all for the help. I'll let everyone know how it all works out when I get the replacement parts today or tomorrow.   



[0] Message Index

[#] Next page

[*] Previous page

Go to full version