Get Answers to your Appliance Repair Questions

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Maytag LAT9356AAE Spin problem  (Read 6383 times)

Offline Camarocam

  • VIP Member
  • Member Since: Feb 2008
  • Posts: 2
Maytag LAT9356AAE Spin problem
« on: February 18, 2008, 11:12:02 AM »

  My washer will not go into the spin cycle, it spins but not at like a normal wash speed not quickly enough to dry the clothes. It worked fine before I replaced the driveshaft seal? The trasmisson spins just very slow. I looked at the bottom where the pulley is, it spins fast no slipping of the belt but if I push the motor in on the slid its like the transmission switchs gears because then the trans speeds up and the bottom pulley slows down but still not as fast as it should be?

Model LAT9356AAE

Offline AJ

  • Technician
  • Member Since: Jun 2007
  • Posts: 10865
  • Country: us
    • - Appliance Repair
Re: Maytag LAT9356AAE Spin problem
« Reply #1 on: February 19, 2008, 11:06:24 AM »

Have you tried a new belt?

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3023
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: Maytag LAT9356AAE Spin problem
« Reply #2 on: February 20, 2008, 10:10:40 AM »
Apparently somewhere in your repair process, the spin bearings are binding.

1.To what extent did you tear down the machine?

2. Did you have  cause to remove the large drive pulley on bottom for any reason?
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman


Maytag LAT9356AAE odd brake problem when trying to spin

Started by Brett24

Replies: 0
Views: 137
Last post October 06, 2017, 11:35:05 PM
by Brett24
Maytag Washer Spin & Drain Problem

Started by lulubovary

Replies: 1
Views: 5639
Last post March 11, 2008, 04:43:09 PM
by Repair-man
Maytag Performa spin problem

Started by chrismorrow02

Replies: 3
Views: 10205
Last post December 15, 2008, 07:21:33 PM
by Repair-man
Maytag Neptune Spin Problem/Contoller board not burnt

Started by sdocsmith

Replies: 3
Views: 4131
Last post January 08, 2009, 02:52:28 PM
by whirlpooltech
maytag neptune stackable slow spin no drain problem

Started by kellonnie

Replies: 0
Views: 3178
Last post November 11, 2009, 08:56:12 AM
by kellonnie
Maytag washer spin problem

Started by Bill

Replies: 4
Views: 3900
Last post February 03, 2011, 05:17:20 PM
by JWWebster