I just hope it helps somebody out! I looked and looked and couldn't find more than the service pointers, and t/s an appliance is something new. However I am familiar enough with multimeters that I went looking for the issue. This is easy enough to verify with the ignitor/burner out of the oven.
1. Check for resistance between wiring harness connector and elbow. Should be 0 Ohms.
2. Check for resistance between wiring harness connector and ignitor tip and it will probably read infinite.
Upon further examination you will notice it is actually coated in a fine soot.
If you take measurement #2 from close to the ceramic or on the backside you might get some inconsistant measurements showing continuity. However after a good cleaning it should also show 0 Ohms from anywhere!
By the way thanks for this resource it helped immensly!