Get Answers to your Appliance Repair Questions

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: GE washer stuck in spin cycle on "regular", OK in perm press..?  (Read 8962 times)

Offline Black88GTA

  • VIP Member
  • Member Since: Sep 2009
  • Posts: 7
Re: GE washer stuck in spin cycle on "regular", OK in perm press..?
« Reply #10 on: September 02, 2009, 01:29:04 PM »

Thanks for the explanation and part number, I was able to find an interchange part online for $20.

Is it a really labor intensive job to replace this ring?  Is it replaced from the bottom, or do parts need to come out through the side panel?  I'd order it and take a stab at replacing it, but not if it's going to require me to dismantle the entire thing in my kitchen...

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3023
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: GE washer stuck in spin cycle on "regular", OK in perm press..?
« Reply #11 on: September 02, 2009, 02:43:14 PM »
Actually the repair is done from the front without removing the machine from its location at all. There are some springs holding the tub down there which must be popped off so you can jimmy the tranny up a few inches to slip the old snubber out and slide the new one in. All in all it's a simple procedure. Sorry there are no manuals for this machine here.
You'll find some screws along the bottom of the front panel to remove it.
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman


washer shaking during the spin cycle and "Walking" during spin cycles also

Started by dnunley

Replies: 6
Views: 5184
Last post February 09, 2011, 06:43:50 AM
by jumptrout51
Kitchenaid Washer Agitator Stuck during the Spin Cycle

Started by TechnicianBrian

Replies: 1
Views: 5296
Last post July 03, 2008, 10:30:35 AM
by JWWebster
Washer gets stuck in a prepetual spin cycle and door stays locked

Started by jmaloney82

Replies: 5
Views: 5269
Last post December 17, 2008, 09:50:38 AM
by Repair-man
GE frontload washer says "door locked" and won't cycle.

Started by hhrussell

Replies: 1
Views: 8316
Last post April 27, 2009, 04:30:36 AM
by Repair-man
Maytag washer transmission pulley locks up and won"t spin

Started by mattlwoo

Replies: 6
Views: 14667
Last post September 10, 2009, 02:38:06 PM
by mattlwoo
GE Commercial Coin-Op Washer "No high speed final spin"

Started by Shanahan

Replies: 7
Views: 7006
Last post February 02, 2010, 04:44:22 PM
by JWWebster