I use a 1/8th inch drill bit and I am careful not to go too deep. Dont want to hit the shaft. The zoom oil telescoping spout will fit just right in the hole. Fill up the cotten wells on both sides of the motor and work the motor with your hand to free it up the stiffness. I mix in a little bit of rust buster too! That will really get it loose.
May the hinges of our friendship
never grow rusty.
About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL