Get Answers to your Appliance Repair Questions

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Need advice on Maytag agitator shaft being hot.  (Read 2064 times)

Offline traperto

  • VIP Member
  • Member Since: May 2009
  • Posts: 1
Need advice on Maytag agitator shaft being hot.
« on: May 14, 2009, 04:40:40 PM »

I just put in a tub bearing and seal kit per manual and after spinning the machine for approximately 4 minutes like called for the part where you screw down the inner tub was to hot to hold your fingers on. Is this normal or should I take it back apart? Oh I just hand tightened the screw down part of the seal so I don't think I over tightened it but I do think that was as far as it would go. Would just the friction on the carbon seal do this? The tub is sitting down all the way. I doubled checked and I put the other part of the seal all the way down to the bottom of the outer tub. The spin cycle was quite, no unusual sound from the transmission. I hope I haven't screwed up the new parts because they are to high to replace again.


Model LAT9206BAE


Agitator shaft agitated.

Started by dwhite65

Replies: 2
Views: 3255
Last post February 26, 2008, 10:07:28 AM
by dwhite65
22001821 Maytag Washer Agitator

Started by AJ

Replies: 0
Views: 4926
Last post August 02, 2009, 04:41:47 PM
by AJ
Maytag Performa Washer agitator not advancing, just moving back and forth

Started by dltarrant

Replies: 9
Views: 6891
Last post October 30, 2011, 08:05:42 AM
by dltarrant
maytag mav6257aww Agitator want come out

Started by Rabastan

Replies: 6
Views: 1216
Last post November 27, 2014, 10:43:43 PM
by Rabastan
Maytag A207 Agitator/Drum removal

Started by humboldtsean

Replies: 18
Views: 4094
Last post March 14, 2015, 11:21:00 AM
by humboldtsean
Maytag Bravos XL - Error Codes showing up after Replacing Bearing Shaft Kit

Started by Blaiser

Replies: 4
Views: 591
Last post March 18, 2017, 07:37:53 AM
by Blaiser