Get Answers to your Appliance Repair Questions

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Kenmore/Whirlpool spin and agitator noisey  (Read 2703 times)

Offline bigcropcircle

  • VIP Member
  • Member Since: Apr 2009
  • Posts: 1
Kenmore/Whirlpool spin and agitator noisey
« on: April 05, 2009, 09:23:40 PM »

Hello all! First time here...

Our Kenmore Series 90 washer has been making a noise for maybe a a couple weeks or so and has now reached an uh-oh stage. Bought a Whirlpool DIY manual to find little information regarding my findings.

So here goes - the agitator skips or doesn't rotate erratically during the spin cycle and presumably - the noise. Since I don't have the technology or the intellect to film and attach a file, the sound will have to be spelled out; so think old comic book. It's kind of a rouw-rouw-rouw sound. Each skip will make the sound. I've pretty much had the entire drive sub-system laid out on the floor and to my mind, nothing obvious stands out. I have found the that I can hold the agitator shaft (agitator removed) while the basket is spinning - if that means anything. My wife also mentioned that sometimes the spin sycle won't effectively remove all the water as it once had. If there is some other detail I've left out except the sound, please don't hesitate to ask. (That blue spark that occurred once when I jumped the lid switch connector has gone away so I'm no longer startled by it.) The long and short of it is that I don't know where to start. If need be, I'll just buy a new tranny and hope for the best - but I'm somehow not convinced the problem is that big.

Any help you folks can provide will be greatly appreciated.

Thank you,

Model 110.23932200

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3023
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: Kenmore/Whirlpool spin and agitator noisey
« Reply #1 on: April 05, 2009, 10:29:23 PM »
Why not start with a clutch kit? It has a new clutch band, plus a plastic cam that triggers the brake to release. Might solve the problem without a new tranny, but in either case, would be a good start at a cheaper cost.

Clutch kit- click
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8809
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: Kenmore/Whirlpool spin and agitator noisey
« Reply #2 on: April 05, 2009, 10:47:42 PM »
If it agitates during spin that is a bad tranny.
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL


Kenmore washer by whirlpool, slow spin

Started by deemessingup

Replies: 2
Views: 7769
Last post November 12, 2007, 02:47:14 PM
by deemessingup
Kenmore washer agitator spins when washer is in spin mode w/awful clunking sound

Started by snowell

Replies: 6
Views: 11977
Last post November 20, 2008, 02:30:13 AM
by snowell
whirlpool washer, drum spins, but agitator agitates during spin cycle!

Started by larry39

Replies: 6
Views: 8907
Last post May 05, 2009, 11:52:56 AM
by Al Capone
whirlpool top loader washer - minimal spin, agitator not 100%

Started by Rochelle

Replies: 8
Views: 5886
Last post April 17, 2011, 06:34:38 AM
by Rochelle
Kenmore (Whirlpool) no spin

Started by rego

Replies: 0
Views: 1108
Last post January 08, 2012, 09:03:59 AM
by rego
Kenmore (Whirlpool) Washer won't spin on normal cycle - will on permanent press

Started by 1brian

Replies: 22
Views: 19968
Last post June 08, 2012, 03:46:50 PM
by AJ