Get Answers to your Appliance Repair Questions

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Whirlpool Washer Won't Spin  (Read 3421 times)

Offline TechnicianBrian

  • Technician
  • Member Since: Dec 2007
  • Posts: 390
  • Country: us
Whirlpool Washer Won't Spin
« on: September 19, 2008, 05:11:12 PM »

Model #LA8800XSW2icon, This unit would fill with water and agitate the clothes, but would not spin or drain the water from the tub. Looking like a classic lid switch issue, I got right to work at solving this problem.

As I mentioned in a previous post, the lid switches are used as an interlock to protect the user from injury while the washer is spinning at a rather high RPM. But unlike the newer model mentioned in the post, this older model will agitate just fine with a switch that has failed. It isn't until the timer advances to the spin and drain portion of the cycle where the open circuit to the motor results in this problem. If you compare the circuit diagrams (over simplified to reduce cluter) from each post, you should see why.

The switch on this unit didn't require to much trouble shooting because when the actuator button was pressed, there was no typical snap felt from the contacts closing. Then when the resistance check was made between the two terminals, the failure was verified. Installed a new lid switchicon in this washer and had it back up and running in no time.

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3023
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: Whirlpool Washer Won't Spin
« Reply #1 on: September 20, 2008, 07:23:01 AM »
One quick question...are your fingerprints always that red in blowups or have you been eating Atomic Fireballs again?  :)
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8809
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: Whirlpool Washer Won't Spin
« Reply #2 on: September 20, 2008, 01:05:07 PM »
Wow that was an old direct drive washer. No neutral pack needed for that baby. No pesky screws in the motor clamps either.
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL


Repair Guide: Whirlpool Direct Drive Washer - No agitate or spin

Started by AJ

Replies: 13
Views: 38585
Last post January 02, 2009, 01:09:38 PM
by AJ
whirlpool belt drive washer won't spin

Started by mthd60sprty

Replies: 7
Views: 11947
Last post June 06, 2013, 08:42:12 AM
by fairbank56
Kenmore washer by whirlpool, slow spin

Started by deemessingup

Replies: 2
Views: 7771
Last post November 12, 2007, 02:47:14 PM
by deemessingup
whirlpool washer model LXR9245EQ1- won't drain-slow spin

Started by fixmeplz

Replies: 2
Views: 10578
Last post January 16, 2008, 10:13:02 PM
by JWWebster
Whirlpool Washer - No Agitate or Spin

Started by AJ

Replies: 0
Views: 4975
Last post December 27, 2007, 07:58:27 PM
by AJ
Whirlpool Washer - Washer will not pump out or spin

Started by AJ

Replies: 5
Views: 6391
Last post March 31, 2008, 12:53:52 PM
by AJ