Get Answers to your Appliance Repair Questions

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   AppliancePartsPros 

Author Topic: Lg dishwasher ldf6810st  (Read 1361 times)

Offline Doprider

  • VIP Member
  • Member Since: Aug 2015
  • Posts: 4
Lg dishwasher ldf6810st
« on: August 23, 2015, 02:39:33 PM »

what is the function to the flow sensor part #6501dd2001a. What things can happen if it goes bad? Ian not getting any error codes but test mode 4 water does not stop at 295, and thermistor said 34/35 goes back and forth. Also first code say 3h/u1 instead of 3h/02. Anyone have any support to offer. Thank you!

Offline domain

  • Technician
  • Member Since: Nov 2012
  • Posts: 2610
  • Country: us
    • Buy me a beer through paypal
Re: Lg dishwasher ldf6810st
« Reply #1 on: August 23, 2015, 04:20:02 PM »
It won't stop counting  if you are filling with test mode. Those weird numbers are software numbers

Offline Doprider

  • VIP Member
  • Member Since: Aug 2015
  • Posts: 4
Re: Lg dishwasher ldf6810st
« Reply #2 on: August 23, 2015, 05:21:32 PM »
Thank you so much for the response. Do you know anything about the flow sensor attached to the float meter and inlet water tank located on side of dishwasher. I am have a low flow problem with jet but No error codes. I have gutted it, cleaned it, it is getting plenty of water. Is the dishwasher supposed to start and stop a few time before the motor reaches top speed. Thank you for your help

Offline domain

  • Technician
  • Member Since: Nov 2012
  • Posts: 2610
  • Country: us
    • Buy me a beer through paypal
Re: Lg dishwasher ldf6810st
« Reply #3 on: August 23, 2015, 08:38:50 PM »
I'd make sure that that the arms holes are not plugged up. Flow Meter ONLY controls water flow into the washer. You have plenty of water? You are ok there!

Offline Doprider

  • VIP Member
  • Member Since: Aug 2015
  • Posts: 4
Re: Lg dishwasher ldf6810st
« Reply #4 on: August 23, 2015, 11:14:33 PM »
Could bad gasket in the sump area be the cause of bad water pressure. They were pretty gunked up. I ordered new ones to replace them. All valves and spray arm holes are free of debris.  Is is normal for for it to take a few tries for the motor to get to full speed.

Offline domain

  • Technician
  • Member Since: Nov 2012
  • Posts: 2610
  • Country: us
    • Buy me a beer through paypal
Re: Lg dishwasher ldf6810st
« Reply #5 on: August 24, 2015, 12:17:49 AM »
They ramp up and down. Yes.

Offline Doprider

  • VIP Member
  • Member Since: Aug 2015
  • Posts: 4
Re: Lg dishwasher ldf6810st
« Reply #6 on: August 24, 2015, 11:45:16 AM »
Is it possible that the motor is worn out and not spinning as fast as is should be? Is they a way to test this?

 

LG Dishwasher Model LDF6810ST Shut-off issue

Started by vwforonda

Replies: 3
Views: 3625
Last post August 14, 2012, 10:07:18 AM
by AJ
LG LDF6810ST Dishwasher

Started by mrhud

Replies: 3
Views: 2798
Last post September 15, 2012, 02:09:05 PM
by mrhud
LG LDF6810ST Dishwasher whistling

Started by abracadabra

Replies: 8
Views: 12791
Last post April 21, 2015, 06:47:20 PM
by abracadabra
Replace Sump on LG LDF6810ST/02 Dishwasher

Started by brinkerthr

Replies: 2
Views: 700
Last post May 24, 2016, 12:44:49 AM
by tgoods
Whirlpool Dishwasher GU1200XTLQ1 Dead, clean light blinks.

Started by barb

Replies: 2
Views: 10924
Last post August 11, 2007, 08:05:47 AM
by barb
Whirlpool dishwasher manual

Started by naes

Replies: 15
Views: 26703
Last post August 06, 2007, 05:26:57 PM
by AJ