Get Answers to your Appliance Repair Questions

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: GE frontloader WBVH5100HWW door locks/unlocks/locks again then fill and drain  (Read 1295 times)

Offline nolazach

  • Technician
  • Member Since: Sep 2011
  • Posts: 460

Error codes stored were E70, E22, and E23.   
I checked the fill time and the pressure differential switch.  I also checked the motor and cleaned it and the trap.  The codes were for Keypad error, fill timeout and flood drain.  But when checking in diagnostic nothing stuck as as the cause of the problem. 
     The drum does turn as well.

   Based on the information at hand I ordered a control board.  IIt took only three days to come in, but every day I was called by my 85 year old customer asking if the part was in.   She was upset when my diagnosis was wrong.  Heck I hate being wrong.
  But changing the board did not fix the issue.

  What is next, door switch?
 I mean this is crazy.

  You set it, it locks, then unlocks then locks then fills, then drains until you shut it off.

In my opinion that screams control board.


WP WFW95HEXW0 Door locks, won't run

Started by knudsen

Replies: 6
Views: 1834
Last post August 15, 2015, 07:00:42 PM
by knudsen
Maytag washer transmission pulley locks up and won"t spin

Started by mattlwoo

Replies: 6
Views: 14656
Last post September 10, 2009, 02:38:06 PM
by mattlwoo
Noisy Washer--then locks up

Started by sparky823

Replies: 4
Views: 2438
Last post November 12, 2011, 12:02:47 PM
by JWWebster
maytag neptune front loader wont drain and now wont fill with water and spin

Started by tmcleary

Replies: 1
Views: 3645
Last post September 04, 2012, 05:42:32 PM
by Bailey
Samsung frontloader WF431AB - no fill error

Started by Johncanfixit

Replies: 1
Views: 2190
Last post April 08, 2013, 02:23:42 PM
by domain
Maytag - Replaced Belt & Pulley, spins a few revolutions then locks up

Started by Bartman

Replies: 2
Views: 746
Last post February 14, 2015, 10:16:12 PM
by Joey_Bullock