Get Answers to your Appliance Repair Questions

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Gemini clock 12001661 part changes?? Or a crackpot customer??  (Read 1729 times)

Offline johnp358

  • VIP Member
  • Member Since: Nov 2013
  • Posts: 1
Gemini clock 12001661 part changes?? Or a crackpot customer??
« on: November 05, 2013, 08:50:02 AM »

I replaced this clock for a customer who had a F1-1 code.  Since then the code has not reappeared but the customer is complaining that the timer does not shut off when she opens the door.  For example in the upper oven there is a toasting function that lasts for 2 minutes and when it is done it says "end".  With the old part she would open the door and the "end" disappeared but with this new part she has to press cancel, opening the door does not take it off.
This part was so expensive!! Please help

Offline RegUS_PatOff

  • Technician
  • Member Since: Dec 2007
  • Posts: 1410
  • Country: us
Re: Gemini clock 12001661 part changes?? Or a crackpot customer??
« Reply #1 on: November 06, 2013, 08:21:40 PM »
has she tried closing the Door when it says "
After leaving this Earth, "Do you want the smoking or non-smoking section?"


12001661 Maytag MER6770 series Oven Clock Control Board Assembly

Started by AJ

Replies: 0
Views: 7028
Last post October 30, 2009, 07:50:52 AM
by AJ
Range Clock Control Replacement - part #8523666

Started by AJ

Replies: 0
Views: 3031
Last post March 21, 2011, 05:45:28 PM
by AJ
Maytag Gemini Temp Sensor Problem

Started by csala

Replies: 3
Views: 8717
Last post December 17, 2007, 10:25:04 PM
by AJ
Whirlpool Built in oven clock is blank and oven beeps when not on

Started by Ryan

Replies: 4
Views: 5540
Last post August 06, 2008, 04:47:54 PM
by Ryan
control panel clock and oven will not work

Started by Pens Fan

Replies: 3
Views: 5712
Last post November 04, 2008, 06:38:02 PM
by Pens Fan
Cannot find Amana range part

Started by SGTiger

Replies: 2
Views: 3222
Last post December 28, 2008, 03:48:37 PM
by SGTiger