Forum Index > Washer Repair

Cabrio wtw5600xwo

(1/2) > >>

been working on this washer for a few days no for a no spin. went to diag. mode and got washer to spin. so i figured it was a bad motherboard. replaced the bored and went into calibration mode and as soon as it goes in all the leds go out and lid led starts flashing nonstop. bad lid switch?

Hi, you need check Rotor position sensor, on the rotor about $35.00

the rotor, is on the tub that the belt attaches to?

location of rotor sensor

Sorry Jason... the wtw5600xwo  is a VMW No Rotor to be found go to 


[0] Message Index

[#] Next page

Go to full version