Hey Guys, I have a ge washer model wjrr417oe4ww and it has a bad tub bearing and seal, and water must have leaked down and fried the bearing on the bottom of the transmission also.
My question is, is it possible to change this bearing? the transmission is part # WH38X10002
I already have informed the customer of this costly repair and they are letting me use the washer as a guinea pig. So any ideas at all would be helpful and appreciated.
I am thinking I might use a gear puller to pull the clutch plate off. If it is very tight though I could warp the clutch plate.
Thanks in advance for any ideas and brainstorm, I have read a little bit and they say this cant be done but they have said that about bearings in the past, so I believe it is possible.