Get Answers to your Appliance Repair Questions

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Whirlpool Duet Washer - How to remove the pump assembly  (Read 1635 times)

Offline AJ

  • Technician
  • Member Since: Jun 2007
  • Posts: 10865
  • Country: us
    • - Appliance Repair
Whirlpool Duet Washer - How to remove the pump assembly
« on: July 21, 2012, 08:15:38 AM »


The pump assembly can be accessed once the toe panel has been removed.

To remove the pump assembly, begin by opening the door covering the wiring harness connector and disconnect the wiring harness from the pump motor terminals.

Remove the screw securing the pump assembly to the washer frame. (Fig. 4-23) Once the pump is removed the drain hose and tub outlet hose can be removed.

To clean out the large item filter, turn the large knob counterclockwise and pull it out. (Fig. 4-24)

NOTE: It is recommended that a small pan be placed under the pump prior to removing the large item filter.
There will be water in the pump housing.


8178076 L-68 Whirlpool Duet Front Loading Washers Service Repair Manual


Video: Whirlpool Duet Front Load Washer Water Pump Clean Out.

Started by AJ

Replies: 0
Views: 11334
Last post November 28, 2007, 09:58:47 PM
by AJ
8181684 Whirlpool Duet Front Load Washer Water Drain Pump

Started by AJ

Replies: 0
Views: 15133
Last post March 12, 2009, 12:20:48 AM
by AJ
Video: How To Replace a Water Pump On A Whirlpool Made Direct Drive Washer

Started by AJ

Replies: 0
Views: 12630
Last post August 10, 2007, 08:42:54 PM
by AJ
Photos: Whirlpool Duet washer with bad bearings, only 2.5 years old!

Started by AJ

Replies: 21
Views: 46374
Last post May 23, 2013, 08:22:19 PM
by Rick32k
How to replace a Whirlpool Duet washer bellow tub door seal

Started by AJ

Replies: 39
Views: 110435
Last post December 24, 2013, 12:16:46 AM
by GB-NC
Whirlpool Washer - Washer will not pump out or spin

Started by AJ

Replies: 5
Views: 6408
Last post March 31, 2008, 12:53:52 PM
by AJ