Get Answers to your Appliance Repair Questions

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: KENMORE WASHER 11028002010 spin cycle  (Read 3928 times)

Offline mrfixitupper

  • VIP Member
  • Member Since: Jun 2012
  • Posts: 1
KENMORE WASHER 11028002010 spin cycle
« on: July 05, 2012, 06:59:10 PM »

Okay, I'm lost on this one. So, I'm working on a Kenmore 11028002010 top load HE washer. The original problem: Tranmission basket gear stripped out. I replaced the gearcase and all bushings and ran the calibration. Everything turns free and easy as it should and clutch works properly, but each time it trys to sense the load it stops and the lid lock LED flashes for about 5 min before unlocking. An F7-E1 error code comes up which corresponds to the washer can't detect basket RPMs. Tested the RPM input on the board; the sensor is getting 13VDC as it should but is outputting a constant 5VDC instead of alternating 0 and 5VDC as it should when the basket is turned slowly. Replaced the clutch/assembly and same problem. It will spin in both the low spin and high spin manual cycles, however, it stops after about 1 min. and brings an F7-E7 code which isn't even in the repair manual but seems to be a "Motor wouldn't reach target RPM" error. Still am getting a constant 5VDC reading as basket spins. Think the new clutch assembly could also be bad or am I going about this the wrong way?

Offline haroldsappliance

  • Technician
  • Member Since: Nov 2011
  • Posts: 649
  • Country: us
    • Appliance repair
Re: KENMORE WASHER 11028002010 spin cycle
« Reply #1 on: July 05, 2012, 07:27:33 PM »


kenmore washer clicking on spin cycle

Started by seek1369

Replies: 8
Views: 16022
Last post January 30, 2009, 08:55:05 PM
by JWWebster
Kenmore 90 Series Washer with Spin Cycle issues

Started by B_con

Replies: 2
Views: 6788
Last post February 28, 2009, 08:27:56 PM
by JWWebster
Kenmore 70 Series Washer - no cold water, weak spin cycle?

Started by Q451990

Replies: 10
Views: 9067
Last post January 28, 2010, 08:31:18 PM
by viking351
Kenmore Washer makes loud scrapping sound in spin cycle

Started by ibbumpn

Replies: 4
Views: 5423
Last post March 09, 2011, 04:08:32 PM
by ibbumpn
Kenmore (Whirlpool) Washer won't spin on normal cycle - will on permanent press

Started by 1brian

Replies: 22
Views: 20001
Last post June 08, 2012, 03:46:50 PM
by AJ
Kenmore washer stops at spin cycle 110.44836300

Started by browniiiz

Replies: 5
Views: 3792
Last post May 03, 2012, 08:13:35 PM
by jumptrout51