ApplianceJunk.com

Forum Index => Washer Repair => Topic started by: 8857mama on September 24, 2008, 11:38:41 AM

Title: Kenmore (Fridgidaire) Front Load washer
Post by: 8857mama on September 24, 2008, 11:38:41 AM
push start - motor runs for 5-10 seconds - shuts down - replaced control panel - new control panel came with notice that front loader don't need reed switch anymore - diagnostic code says magnet or reed switch - magnet is in place - why doesn't this junk run?

Model 417.44152400
Title: Re: Kenmore (Fridgidaire) Front Load washer
Post by: Repair-man on September 24, 2008, 11:52:52 AM
The motor speed control is likely bad, not the control panel. There's a tech sheet inside the lower panel which will guide you thru the diagnostics.