GE WBSR3140G3WW Cant get it to work

[isappliance]

I replaced the lid switch and motor on this GE Top load and the machine. All it does is fill up with water then sits there a few minutes before draining. It will not start any cycles. The motor shows that it sits on standby mode and I can not get any information on this machine. Any help is appreciated.

[haroldsappliance]

The fuse may be the problem. It's located in the taped wiring on front right side of washer.
http://www.repairclinic.com/PartDetail/Thermal-Fuse/WH49X10055/1475932?modelNumber=WBSR3140G3WW

[isappliance]

We checked the fuses, the pressure switch, and it is the right motor for the unit and it still refuses to do a thing. Leave it to GE to over complicate things.

[haroldsappliance]

Did u reset by doing the lid deal seven times?

[isappliance]

It has been reset with the same symptoms.

[hesterappliance]

I had one that was acting like your it was bad connection at the motor

[apu]

 
  All I can find so far, I'll keep digging.
 
 
 Jim

[isappliance]

Appreciate the help guys.

[haroldsappliance]

Try unplugging for a full minute and the reset again.

[JWWebster]

Is the idiot light on the motor blinking?

[isappliance]

The idiot light is blinking every 1 second.

[AJ]

Did you ever get it working?
If so what ended up being the problem?

[isappliance]

Yes I did. We took out the timer and found a burnt wire coming from the timer. We changed out the wire and hooked up the old timer. After that the machine kicked right up.