wpl cabrio washer

[All Brand]

Mod wtw6400sw2 washer works one load next load get LD fault but no water is left in tub.It does have a high drain but has worked for years with out a problem, Pump was replaced also unit will start up on its own,after cycle finished?Have also replaced main control .any one else run in to this problem.

[scrapiron]

Probably some clothing in the outer tub. Pull the basket & take a look.

[JWWebster]

Does it have a problem with bumping the side of the washer? I am working on one outside right now that seems to have worn rods. It has no bungies. What controls the lateral movement Scrappy?

[JWWebster]

[scrapiron]

They just swing back & forth on the support rods. Real basic. From your video, looks like it's working fine. I work on a lot of these. Common things I run into is clothing in outer tub (usually causes F-51 error or just covers up the pump inlet), coins in the drain pump, worn suspension rod bushings ( makes a "crunchy" sound as the mechanism moves) there's a kit with all 4 rods & balls/bushings. And my favorite: the bad bearings. I'm getting good at installing the bearing/shaft/seal kit. Only 45 - 50 minutes now.