Free Service - Appliance Repair Help & Troubleshooting

Author Topic: Maytag MAH8700 starts to SPIN for 3-5 seconds then stops  (Read 229 times)

Offline Gabe401

  • VIP Member
  • Member Since: Jan 2016
  • Posts: 1
Maytag MAH8700 starts to SPIN for 3-5 seconds then stops
« on: January 23, 2016, 09:28:57 PM »
I have a Maytag Neptune MAH8700AWW that is unable to complete a spin cycle. When it tries to start spinning, it will ramp up for a few (+/- 3 sec) and then stop.

I have tried it with an empty load. Machine is drained. Water pump works and door latch seems to work.

Ran a Quick SPIN from the Service manual. It runs fine at 105 RPM, but then when it tries to ramp up to the next level it fails around 150 RPM and stops.
Checking the Diagnostic Codes, I am finding several 2E and a single 3E code. Board input and Board output tests seems to pass correctly.

Any help on where to start looking next would be greatly appreciated.

Offline AppTek

  • Technician
  • Member Since: May 2012
  • Posts: 74
  • Country: ca
Re: Maytag MAH8700 starts to SPIN for 3-5 seconds then stops
« Reply #1 on: January 24, 2016, 02:03:17 PM »
I had one of those this week. Take the control board and look at it closely. The one I had, the control board is totally covered in a rubberized coating to protect it from moisture. however, the diodes and resistors on the board were totally corroded, even some of the pins on the IC's were totally rusted. $445 plus tax canadian retail for that board lol. 4 years old. Nice job Samsung.

 

Maytag Atlantis Washer, fills starts stops

Started by crazeddad

Replies: 10
Views: 8210
Last post August 17, 2008, 09:57:54 AM
by Repair-man
maytag washer lat2500aae squeels for a couple of seconds at the begining of spin

Started by dmarino

Replies: 3
Views: 1681
Last post July 29, 2012, 05:22:37 PM
by Bailey
Maytag stackable stops at rinse cycle and wont advance to spin??

Started by Moedee

Replies: 20
Views: 1801
Last post January 26, 2015, 06:54:39 PM
by Blaiser
Maytag Neptune MAH4000AWW - No Spin.

Started by larry

Replies: 39
Views: 74034
Last post February 21, 2011, 01:22:14 PM
by bwhelan
Maytag washer mah4000aww spin cycle

Started by evo100

Replies: 1
Views: 5614
Last post December 25, 2007, 09:41:02 PM
by AJ
Maytag Neptune Washer - No Spin

Started by AJ

Replies: 6
Views: 8709
Last post February 20, 2008, 12:41:13 PM
by AJ