Just under 5 years old, I love the high speed extended spin to extract water.
No led blinking on the inverter/motor.
Using Shawn`s tutorials:
-Fuse in harness meters ok
-Lid switch meters ok
-Took off hose on water level, fairly clean, can hear sensor click when sux/blow in it.
-Wires to Washer Shaft & Mode Shifter Assembly checks out at 93 ohms.
-Tried to no avail resetting inverter board opening/closing lid
-12vdc present on far right motor connector 3-4-5 terminals during suppose to spin up.
I have the red label 175d5106g015 motor part that can take out the Washer Shaft & Mode Shifter Assembly and I am infamous for opening the lid to let things soak or adjust water levels (I didn`t know there was a problem till now)
What do? Throw in a new WH20X10058
motor/inverter and strip out the harness fuse and if it still doesn`t work right get a new shifter assembly?