Author Topic: wont advance  (Read 607 times)

Offline greg

  • VIP Member
  • Member Since: Jul 2009
  • Posts: 14
wont advance
« on: February 28, 2012, 12:29:02 AM »
I have a Kenmore Elite washer that runs fine until it gets down to 2 min. mark on the digital read out and it wont advance any further model # 110.45862400 serial #css2615412 I dont even know where to start I dont have a tech manual any advice or where I can get a tech manual at sure need help and fast thanks Greg

Offline jumptrout51

  • Technician
  • Member Since: Nov 2007
  • Posts: 1879
  • Country: us
    • Buy me a beer through paypal
Re: wont advance
« Reply #1 on: February 28, 2012, 06:53:41 AM »
Take a Kid fishing.

Offline greg

  • VIP Member
  • Member Since: Jul 2009
  • Posts: 14
Re: wont advance
« Reply #2 on: February 28, 2012, 11:34:30 AM »
nope no codes

Offline jumptrout51

  • Technician
  • Member Since: Nov 2007
  • Posts: 1879
  • Country: us
    • Buy me a beer through paypal
Re: wont advance
« Reply #3 on: February 28, 2012, 03:33:53 PM »
The manual posted above will help you. I would start with the door latch and the drain pump.
Make sure they are both working correctly.
Take a Kid fishing.

 

kenmore washer wont spin

Started by futch13

Replies: 5
Views: 2788
Last post October 09, 2007, 12:28:49 PM
by rickgburton
Help Tromm washing machine wont spin

Started by angeleyes

Replies: 15
Views: 16862
Last post February 13, 2008, 08:19:59 PM
by JWWebster
washer wont spin and sometimes shuts off mid cycle

Started by imharley

Replies: 14
Views: 7373
Last post June 12, 2012, 07:56:35 PM
by Bailey
same as everyone else wont spin with a load make noise

Started by confused and tro

Replies: 4
Views: 2880
Last post October 02, 2008, 09:18:01 PM
by JWWebster
whirlpool ultimate care II leaking water from bottom front and wont spin

Started by vasdoc

Replies: 6
Views: 6146
Last post October 12, 2008, 09:20:49 PM
by JWWebster
Won't advance into spin cycle without opening the lid

Started by big t

Replies: 25
Views: 4935
Last post October 13, 2008, 07:45:50 PM
by RegUS_PatOff