Author Topic: Frigidaire Overn does not work  (Read 810 times)

Offline Knipper64

  • VIP Member
  • Member Since: Feb 2012
  • Posts: 4
Frigidaire Overn does not work
« on: February 16, 2012, 05:35:53 AM »
My Frigidaire oven quit working, the burners on top work, put the oven controls are out. When I went to troubleshoot I found a burnt out componet on the electrical control panel. I was going to order a new circuit board panel, but it there anything that would cause the panel to short out? I don't want to replace with a new one and have the same thing happen again?

Could a defective heating element cause it to short? What should I check first?

Model no: FEFL78CBC



Offline AJ

  • Technician
    Administrator
  • Member Since: Jun 2007
  • Posts: 9316
  • Country: us
    • ApplianceJunk.com - Appliance Repair
Re: Frigidaire Overn does not work
« Reply #1 on: February 16, 2012, 05:45:44 AM »
Did you see the replies to the other topic you had started about your oven?

http://appliancejunk.com/forums/index.php?topic=9450.0

most likely your bake element shorted to ground & took control, you can test element with a meter.
clock #  AP3764682   bake # AP2126365
 
may want to get a new overlay too. # AP2126499



Hope you find our site helpful.

 

Frigidaire Range stove will not work

Started by chaneyann

Replies: 8
Views: 5292
Last post November 27, 2008, 03:58:19 AM
by Repair-man
Frigidaire burners work, oven doesn't

Started by C_Brazil

Replies: 2
Views: 5866
Last post January 09, 2010, 02:38:15 PM
by C_Brazil
Frigidaire oven temp sensor probe?

Started by jon

Replies: 1
Views: 6571
Last post July 08, 2007, 06:06:26 PM
by AJ
Frigidaire Microwave Turntable Stopped Working

Started by TechnicianBrian

Replies: 0
Views: 3226
Last post April 14, 2008, 10:04:51 PM
by TechnicianBrian
Frigidaire Microwave No Power

Started by TechnicianBrian

Replies: 0
Views: 2877
Last post April 15, 2008, 09:57:53 PM
by TechnicianBrian
Frigidaire Microwave Door Won't Stay Closed

Started by TechnicianBrian

Replies: 0
Views: 3628
Last post April 17, 2008, 07:39:22 AM
by TechnicianBrian