12-2299-10/05 safety valve

[amoorejr35]

I recently installed a new igniter in my oven and I know it worked because I did a quick wire-in and it glowed. In a hurry to install it I forgot to unplug the plug to the igniter/valve. One lead made contact with oven and opened the safety valve for about 10 seconds. After that the igniter never glowed again. I replaced the igniter and it still doesn't glow. What could be the problem? I have power going to the oven. [ 120v]

[bigbuck]

do you have a mod #?, did you check safety valve with meter?

[amoorejr35]

do you have a mod #?, did you check safety valve with meter?

the igniter is a WB2X9998
the safety valve is NC-4148-5
The oven is 12-2299-10/05

What am I looking for with the meter? Amperage ,Voltage, or Ohms?

[bigbuck]

check ohms with oven unplugged, @ safety valve, if its open , change valve.

[amoorejr35]

Checked from continuity across both leads on valve. Valve is isolated and completely out of circuit. Set greenlee cm-600 meter to ohms and touched both leads across valve terminals. No tone or reading from meter. I guess I fried safety valve?

[bigbuck]

thats it, sorry, it happens.

[amoorejr35]

thanks for the help

[amoorejr35]

Is a Y-30180-1 safety valve and a Y-30128-35af compatable?

[RegUS_PatOff]

Tappan  12-2299-10/05 made by Frigidaire
USUALLY a short of the Gas Valve wires to chassis won't ruin anything,
UNLESS the Wall Outlet polarity is REVERSED.
Check L1, Neutral poplarity