Kelvinator Freezer

[blondejon]

model# Ufs192mmow  I picked up this freezer yesterday.  There is an obvious gap at the top corner.  Hinges need to be replaced?  Any thing else that could cause this gap?  I'm having trouble finding the part#....

[jumptrout51]

Are you sure about this model number?

[theoldstoveguy]

If that is opposite of the hinge it may just need adjusting. If you carefully bend back gasket from the inside of the door ,you should see screws every 6 inches or so. Loosen all the screws on one side and say the top of the door about 2 full turns. realign the door and tighten the screws back up. Small adjustments could be done by heating and shaping the gasket.

[blondejon]

Ufs192mm0w  sorry it's a 0 not an o.  Still not finding any info on it. 

Thanks oldstoveguy.  I'll check it out.