Whirlpool Gold icemaker not working

[Mark L]

I have replaced the optics boards, the control module, and tested the tray thermostat for continuity.  My icemaker fills with water, freezes, but gets stuck there.  When I jump the T and H holes, nothing happens.  Does anyone know what I am missing?

[whirlpooltech]

Could you post the model number of the refrigerator for us, thanks

[Mark L]

Could you post the model number of the refrigerator for us, thanks

It is a whirlpool gs6shaxmb

[whirlpooltech]

Being you have already replaced the optic boards, part # AP3137510 and it fills with water I would go ahead and replace the ice maker.

Here is the ice maker for your model refrigerator.


WHIRLPOOL Complete Icemaker Assembly (8 Cube), part number: AP3182733

[bigbuck]

you could save 30 dollars & order AP3177342  motor module. if your mold is in good shape.

[Mark L]

I have already replaced the control module on the icemaker.  The only thing I didn't replace was the tray.  Could it be anything else?

[bigbuck]

has to be icemaker assy. then! optic board been replaced, make sure optic board plugs are tight. light should be steady on with shutter closed.

[whirlpooltech]

I have already replaced the control module on the icemaker.  The only thing I didn't replace was the tray.  Could it be anything else?

This is exactly why I don't try and rebuild ice makers.
If the ice maker is getting voltage and water I pop a new one in and move on down the road.

[jumptrout51]

To cycle this icemaker using T and H you have to tape the door flap closed,jump T and H,close the door,unplug the refrigerator,re-plug the refrigerator and let the icemaker cycle.

[handsmcgee]

I agree with W/P Change the ice maker because it sounds like a harvest issue with tray heater or sensor. the only way I know to test it I think jump trout explained it best. There is a special tester for the module I think it's made by orion tecnology. Anyone heard of this tester or know where to find them? Kinda tired of meter and jumper wires testing these. this tester plugs into the motor module and will test the circuit and allow to test harvest.

[AJ]

There is a special tester for the module I think it's made by orion tecnology. Anyone heard of this tester or know where to find them?

You talking about this one?

Diagnostic Icemaker Tester for Modular Ice Makers IMT1





Re: Testing an ice maker

It's also listed in our tool list.

Appliance Repair Tools

[handsmcgee]

That's the one. thanx AJ

[AJ]

If you decide to try one be sure to let us know what you think of it.