365-Day Hassle Free Return Policy!  ·  AppliancePartsPros.com
Washer PartsDryer PartsRefrigerator PartsDishwasher PartsRange & Oven PartsAll Appliance Parts

Author Topic: Standard ice maker issue  (Read 1660 times)

Offline barglancy

  • VIP Member
  • Member Since: Jan 2012
  • Posts: 2
Standard ice maker issue
« on: January 20, 2012, 12:18:20 AM »
Whirlpool GS6SHEXMQ00

I had an ice tray with a corroded heater element so I replaced it and the control module while I was at it. 
However now I'm getting no water from the tube into the tray.

I ran a small cord down the water tube from the opening and saw it at the back of the fridge so I assume it's not a frozen line.

I checked the connections between the wiring and the module and they look good.

Any suggestions?


This is the service manual

Offline bigbuck

  • Technician
  • Member Since: Jan 2011
  • Posts: 956
  • Country: us
  • over 30 years repairing appliance
    • Buy me a beer through paypal
Re: Standard ice maker issue
« Reply #1 on: January 20, 2012, 04:51:50 AM »
i would try inlet valve.  O0

Offline barglancy

  • VIP Member
  • Member Since: Jan 2012
  • Posts: 2
Re: Standard ice maker issue
« Reply #2 on: January 21, 2012, 10:10:31 AM »
I was just missing patience.  Went to bed and woke up to ice.  Working like a charm. :)


Ice Maker issue

Started by FixItElwood

Replies: 2
Views: 1907
Last post April 26, 2011, 12:34:06 PM
by JWWebster
Electrolux Bullet Style Ice Maker Issue

Started by clman

Replies: 4
Views: 3423
Last post May 14, 2012, 12:11:38 PM
by clman
Whirlpool Side by Side ice maker issue

Started by neustkg

Replies: 5
Views: 2275
Last post September 13, 2014, 02:29:14 PM
by domain
Samsung RF 4287 Ice Maker Issue

Started by pedavissr

Replies: 0
Views: 249
Last post August 02, 2015, 09:30:51 PM
by pedavissr
Video: See if your Whirlpool Ice maker infrared optics control is working.

Started by AJ

Replies: 2
Views: 60349
Last post August 01, 2007, 12:21:37 PM
by AJ
ED27DQXB01 Do I need to replace the ice maker?

Started by galen

Replies: 5
Views: 5172
Last post August 27, 2007, 07:47:38 PM
by AJ