Just delete the "C" from the model#. You can look up whatever parts you need at Sears.com . Click on the "Parts Direct" link at the top of the home page. The Tech sheet (part# 3951186) should be inside of the washer console if you need service info. NOTE: On Kenmore washers with ATC, unless there is a "tap cold" selection (cold fill only) on the water temp switch, the control MAY add some hot at times during a "cold" water fill, giving the impression of a warm fill. The hot or cold valves are energized independently by the ATC circuit board. The temperature of the water entering the washer is monitored by the temperature sensor (thermistor), which is located in the water hose between the fill valve and the fill spout. The valve on the right (facing the washer) is the water inlet valve. The valve assembly on the left is the dispenser water supply valve.