Hotpoint Range / Stove / Oven Fault Codes

[AJ]

 

Failure Code	Fault Code Description	Solution
F0	Stuck touch pad	Usually means that either the touch pad or the oven control (also called clock or ERC) is defective and needs to be replaced. If this fault code cannot be cancelled, replace the oven control (also called clock or ERC), touch pad, or both.
F1	Stuck touch pad	Usually means that either the touch pad or the oven control (also called clock or ERC) is defective and needs to be replaced. If this fault code cannot be cancelled, replace the oven control (also called clock or ERC), touch pad, or both. Refer to F1 test at the top of this page for more information.
F2  During  BAKE	Control senses oven temperature above 615F-630F	If actual over temperature condition occurred: Look for welded relay contacts on bake or broil relays. If this happens, replace oven control (also called clock or ERC).    If no over temperature condition occurred: Look for a high resistance connection or any other cause of high resistance in the oven temperature sensor circuit. Check sensor, sensor harness and sensor harness connection at sensor and oven control. Replace sensor if found defective.    Remember: Oven control (ERC) measures resistance of sensor circuit, not actual oven temperature.
F2  During  CLEAN	Control senses oven temperature above 915F-930F	If actual over temperature condition occurred: Look for welded relay contacts. If this happens, replace oven control (also called clock or ERC).    If no over temperature condition occurred: Look for a high resistance connection or any other cause of high resistance in the oven temperature sensor circuit. Check sensor, sensor harness and sensor harness connection at sensor and oven control. Replace sensor if found defective. Check door lock switches.    Remember: Oven control (ERC) measures resistance of sensor circuit , not actual oven temperature.
F3  or  F4	Open or shorted oven temperature sensor (RTD)	Check sensor harness and harness connection between oven sensor and oven control. Replace oven temperature sensor (RTD) if wiring is ok.
F7	Stuck touch pad or bad clock	Usually means that either the touch pad or the oven control (also called clock or ERC) is defective and needs to be replaced. If this fault code cannot be cancelled, replace the oven control (also called clock or ERC), touch pad, or both.
F9	Lock switch	Check wiring to door lock switch (the wire harness may be connected wrong). Check for stuck lock switch.

 

Find Parts
Fault Code Index