GE 2800 dishwasher dispenser lid broken

[Jim214]

My lid dispenser just  broke off in my hand...is this a replaceable part?  How do I do it?
Thanks

[rego]

Could you post the model number.

[Jim214]

Gsd2800003

[rego]

You may want to double check your model number if it is a GSD2800D03 these are the replacement parts.  If you are talking about the detergent cup cover for this model the part is part #270966 at www.appliancepartspros.com is AP2039368 it also has a dispenser lever that is part #2330 at the same website AP2039379 . 

To gain access: Please turn power off to the appliance.  You will need to take off the inner door by taking out the screw's around the outside of the inner door and then carefully pull off.  you will then have access to all the parts.

Double check the model number because the parts I listed are for the model I posted.

Hope this helps.

[Jim214]

Thanks for the reply...it is a GSD2800D03.  My eyes are going.  Anyways, I have the inner door off.  Does anyone have a diagram or picture of how the assembly should sit?  The spring & the gadget attached to the lever were lying on the bottom unattached.  It appears that only the lever is broken, I just dont know where the spring goes & how the device should sit.
 

[rego]

Does look like the pieces?
#1 hooks on a groove cut into the dispenser arm, #2 hooks onto a tab built onto the inner door panel.

[rego]

Just to make sure we're on the same page...the part's diagram's don't give me a good visual for wiring or location and I don't have one around right now to open up so I've been searching the web for pictures to help do these look like what you have?

[AJ]

Here are some photo Jim sent me to resize for him. Thought I would just go ahead and post them here too.

[AJ]

Two more...

[rego]

Thanks AJ.

Oy, anyone have any thought's on this one?

JW do you have anything in your archives of sublime knowledge?

[Jim214]

Rego,
Any suggestions?  I ordered the lever & it should be here today, I just need to figure out which way the othere stuff line up inside the door.
Thanks
 

[rego]

Sorry Jim,

I'm having absolutely no luck with getting you pictures. The only diagram I can find is http://www.appliancepartspros.com/partsearch/model.aspx?model_id=209323 which is the closest to your model # I can find. The foam appears to be insulation there is a part #WD1X1348 whether it serves a purpose for the dispenser I can't determine. The last pic. is your cam which appears to have part of the lever still in it part #WD16X300 (discontinued)   It also appears that a lever is broken connected to your timer (a little tough to see from flash) take a look at part #837 timer spring and read the comment's and follow some of the parts links in the comments and see if they look like what you have.

I'm sorry I can't be of more help but just can't find much of anything on this model and many of the parts are discontinued

[JWWebster]

I don't mess with dishwashers that much. Just don't like messing with em.

[Tony543]

My lid dispenser just  broke off in my hand...is this a replaceable part?  How do I do it?
Thanks

I actually have the exact same problem as Jim214. Thanks to the info in this thread I was able to find the replacement lever and order it (Thanks alot for all of that). What I can't figure out is how it goes back together. The picture 008.jpg is the part I am not sure about. How does it line up with the other pieces at the top by the motor?

Thanks