Kenmore model number 110.28932790
Clicking during agitate and spin started a few months ago clothes are cleaned but when removed are “wetter” than normal – replaced dogs – no change
Now there is a slight low banging noise similar to when load is off balance during the spin but it also happens during agitate and there is also a slight burning smell – not sure if its rubber or electrical.
Thanks to your forum, I've checked the lid switch, motor coupling, notches on the agitator and drive shaft (?), all appear to be fine. Water pump was not clogged as I removed and water flowed freely. No oil or water on the floor just some black dust, rubber coupler is a little worn but fine. There does not appear to be any clothes between the basket and the tub but I cannot remove the tub because of the spanner nut. Any tricks to removing without the tool? I've tried vice grips and channel locks but when trying to turn the nut the entire tub moves even with another trying to hold it in place. A hammer and slot screw driver did not loosen it either.
Anything else I can check while I have the washer half apart?