Author Topic: seal on heating element  (Read 899 times)

Offline kellonnie

  • Technician
  • Member Since: Oct 2009
  • Posts: 284
seal on heating element
« on: August 16, 2011, 04:07:26 PM »
is the seal on the heating element ofr this washer no good after it is removed from drum? replaced rear outer drum and had ro remove heating element to seperate drums, cannot get it to seal for the life of me, any suggestions? or replace the element?

Model WM2487HRM

Offline wildimaginations

  • Technician
  • Member Since: Jul 2011
  • Posts: 621
  • Country: us
Re: seal on heating element
« Reply #1 on: August 16, 2011, 06:26:22 PM »
The rubber seal should still be good.  Maker sure that you push the element assembly all the way in and that element sits in the metal bracket inside the tub properly.  Then with an 10mm socket, you should be able to tighten down on the rubber seal.  DO NOT OVER TIGHTEN!!!!

Hope this helps.
Appliance Service Technician
Authorized servicer on LG appliances.
About 45 mins east of San Francisco

 

Maytag MAH3000AWW Door Boot Seal

Started by georgiabowles@msn.com

Replies: 15
Views: 12265
Last post October 16, 2012, 07:51:53 PM
by bigbuck
How to replace a Whirlpool Duet washer bellow tub door seal

Started by AJ

Replies: 39
Views: 76200
Last post December 24, 2013, 12:16:46 AM
by GB-NC
Maytag dependable care stem seal/bearing replacement

Started by michael o

Replies: 3
Views: 4490
Last post December 28, 2007, 12:08:21 AM
by AJ
Input Shaft Oil Seal Kit

Started by jennidoug96

Replies: 3
Views: 2509
Last post June 24, 2008, 09:28:27 PM
by JWWebster
Changing the Performa or Atlantis Tub Bearing and Seal

Started by Repair-man

Replies: 0
Views: 1777
Last post October 24, 2008, 06:37:17 PM
by Repair-man
Maytag Atlantis washer bearing and seal question

Started by grdnhappy

Replies: 1
Views: 4232
Last post November 10, 2008, 01:00:32 PM
by JWWebster