The release date for the dishwasher is May and the one we were looking at was a pre-production model so if you notice, all the wiring bundles are the same color to the same component. The rep thought that was going to change so you could actually use the tech sheet to check for proper voltages on the correct wires. The tech sheet was also pre-production so it consisted of blocks with lines running to it. Both motors are DC so there isn't much fixing on this one. Either replace the motors or the boards in most cases. As for the drain hose, it loops up the left side around the inlet port (this one fills from the side instead of the normal Bosch method of sump filling) to create the air gap, the water inlet line runs up the middle, and the dryer condensate hose runs down from the vent outlet and terminates just in front of the rear drain hose connection. So all the hoses are on one side instead of the drain on one and the condensate on the other. Looks like a good setup and should prove to be much easier to service then the normal Bosch, but time will tell.