Author Topic: Testing an ice maker  (Read 5028 times)

Offline tgoods

  • Technician
    Moderator
  • Member Since: Jul 2010
  • Posts: 1527
  • Country: us
    • Buy me a beer through paypal
Re: Testing an ice maker
« Reply #10 on: July 24, 2011, 08:59:54 PM »
$108 for an icemaker tester? Don't waste your money. Just jump T to H with an insulated wire.  That will start the icemaker.  Pull the wire out after a few seconds. Then go back the inlet valve, put your meter leads on the valve terminals and wait.  When the ejector fingers reach about high noon the icemaker it will send voltage to the valve for about 7 seconds. The voltage is in series with the mold heater so it won't be 120 VAC, it will be about 107 VAC. The best way to know for sure if it works is to hook it up to water and let it run. I bet you could find fittings to adapt it to your garden hose.  If that's not possible, just fill the icemaker with water.  If your freezer temperature is cold enough, it should eject the ice within an hour or two.

Offline Earl Dryer

  • Technician
  • Member Since: May 2008
  • Posts: 166
  • Country: us
Re: Testing an ice maker
« Reply #11 on: July 27, 2011, 01:49:32 PM »
Make yourself 2 jumper wires 1 that will jump V-L that is the water valve. If water runs to the im the communication to the valve and the valve are good, if not test the valve, it is probably bad (jumper for only a few second). Next make a jumper wire to jump from T-H listen for click (approx 3 sec.) let IM run through cycle, water valve should activate about the same time the arm drops or the notch in the wheel is at 4 o'clock, if no fill occurs replace module (bad contacts behind wheel) but the IM probably should be replaced because the coating on the mold is probably worn also.

Offline AJ

  • Technician
    Administrator
  • Member Since: Jun 2007
  • Posts: 9607
  • Country: us
    • ApplianceJunk.com - Appliance Repair
Re: Testing an ice maker
« Reply #12 on: July 27, 2011, 02:08:42 PM »
Hope you find our website helpful.

 

Video: Testing - Connect and disconnect a push-in ice maker water fill valve

Started by AJ

Replies: 0
Views: 17991
Last post July 30, 2007, 05:53:38 PM
by AJ
Video: How to make your Whirlpool ice maker run for testing and diagnostics

Started by AJ

Replies: 10
Views: 45320
Last post April 16, 2013, 10:40:23 PM
by charlenemhj
When testing an ice maker

Started by Ronyeager

Replies: 11
Views: 2059
Last post August 09, 2011, 08:10:08 PM
by JWWebster
ED5JHGXRQ00 Ice Maker Testing

Started by mpatten2

Replies: 6
Views: 1142
Last post February 23, 2013, 08:04:30 AM
by mpatten2
Video: See if your Whirlpool Ice maker infrared optics control is working.

Started by AJ

Replies: 2
Views: 46957
Last post August 01, 2007, 12:21:37 PM
by AJ
ED27DQXB01 Do I need to replace the ice maker?

Started by galen

Replies: 5
Views: 4230
Last post August 27, 2007, 07:47:38 PM
by AJ