Author Topic: MAYTAG ATLANTIS - BELT INSTALLATION  (Read 1880 times)

Offline skool1

  • VIP Member
  • Member Since: Nov 2009
  • Posts: 5
« on: July 07, 2011, 07:16:00 PM »
I replaced the pump on my washer which caused me to have to replace the belt. I put the belt back on but does not seem to be on tight and I'm assuming that is the reason why my washer shakes during the spin cycle. How do I install the belt and tighten the belt so that my washer will not shake during the spin cycle?? PLEASE HELP!!

Model MAVT734EWW

Offline theoldstoveguy

  • Technician
  • Member Since: Jan 2008
  • Posts: 1495
  • Country: us
    • Buy me a beer through paypal
« Reply #1 on: July 07, 2011, 09:29:47 PM »
Sounds like it's not level. Lift the rear of the machine about 2-3 inches off the floor and set it down. Self leveling. Does not sound right, because replacing a belt shouldn't have any thing to do with out of balance. Machine has an automatic tension on it, no adjustment needed.


How to replace a Maytag - Amana washer water pump and belt.

Started by AJ

Replies: 18
Views: 38611
Last post April 19, 2010, 08:23:29 PM
by JWWebster
Maytag Atlantis Model (MAV9501EWW) Will Not Start

Started by mngambas

Replies: 8
Views: 9592
Last post November 01, 2007, 11:42:28 AM
by mngambas
Maytag washer and dryer belt please

Started by msoffice2020

Replies: 4
Views: 4249
Last post December 24, 2007, 12:46:14 PM
by msoffice2020
Maytag SAV515D Washer how to replace belt

Started by jhernandez1514

Replies: 6
Views: 5569
Last post March 17, 2008, 06:15:02 AM
by Repair-man
Maytag Atlantis Not Draining or Spinning

Started by dconsie

Replies: 11
Views: 14286
Last post June 28, 2008, 05:13:06 PM
by dconsie
Maytag Atlantis Washer, fills starts stops

Started by crazeddad

Replies: 10
Views: 7978
Last post August 17, 2008, 09:57:54 AM
by Repair-man