Author Topic: Kenmore ultra bake oven does not maintain temperature!  (Read 2777 times)

Offline Turtle918

  • VIP Member
  • Member Since: Jun 2011
  • Posts: 1
Kenmore ultra bake oven does not maintain temperature!
« on: June 09, 2011, 11:18:42 PM »
It will pre heat fine but once it reaches desired temperature at some point it will quit heating to maintain temp. If I turn it off and back on it will ignite and heat up again. Just wondering if anyone has solved a problem similar to this or has any trouble shooting ideas so I don't waste money on the wrong parts.

Thanks Josh!!

Model 665.72134300

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8780
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: Kenmore ultra bake oven does not maintain temperature!
« Reply #1 on: June 10, 2011, 09:24:40 AM »
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

 

GE Oven doesn't reach temperature (120-150 Below setting)bAKE

Started by Earl Dryer

Replies: 12
Views: 4664
Last post June 01, 2008, 02:31:32 PM
by RegUS_PatOff
Kenmore oven: Inconsistent temperature

Started by murphycc

Replies: 10
Views: 2047
Last post November 18, 2012, 10:16:05 AM
by JWWebster
Whirlpool oven "bake" setting doesn't light up.

Started by jaworf

Replies: 6
Views: 3711
Last post August 10, 2008, 08:33:54 AM
by jaworf
Sears Kenmore Double Wall Oven 24"

Started by tubcust

Replies: 3
Views: 2548
Last post November 09, 2008, 05:03:21 PM
by AJ
Admiral Oven turning itself off after about 15-20 sec after set to bake

Started by Redman

Replies: 1
Views: 1273
Last post December 10, 2008, 03:50:56 AM
by Repair-man
Frigidaire Oven upper element not fully heating up on bake cycle

Started by prconsulting

Replies: 2
Views: 3296
Last post December 28, 2008, 09:20:32 AM
by jumptrout51