Author Topic: Neptune Washer with New Motor - Seems to have a balance issue  (Read 706 times)

Offline bio132

  • VIP Member
  • Member Since: Sep 2009
  • Posts: 12
I replaced the motor of my washing machine. I didn't think much of this at the time, but it has been nagging me ever since that the balance isn't nearly as good as it was before the replacement. During the spin cycle, the thing is violent. Significantly worse than before. I've tried leveling the feet, etc. but it hasn't seemed to help. I don't remember a load going through without stopping and restarting the spin cycle. Even when it gets up to full speed (and hasn't tripped the balance switches), it's fairly bad.

I remember having a tough time getting the weight mounted after replacing the motor. Could it be that I put it in wrong or something? I think I remember the new motor having a different weight and it seems the tub sits a little differently now. I have never had a mildew problem before, but after the motor replacement, there is a part of the door gasket (bottom) that doesn't drain well and has started to mildew (it's the lip of the gasket that is on the bottom of the door opening). Any other ideas?

Thanks!

Model MAH3000AWW

 

12002039 Maytag Neptune Washer Motor Conversion Kit

Started by AJ

Replies: 0
Views: 5346
Last post March 08, 2009, 12:00:54 PM
by AJ
Neptune Washer: New Motor -- New Smell?

Started by bio132

Replies: 1
Views: 1076
Last post September 01, 2009, 04:50:24 PM
by Repair-man
Maytag Neptune Washer Not Spinning - Blown 10A Fues on Motor Board

Started by frgivn

Replies: 2
Views: 4777
Last post November 08, 2009, 06:58:38 AM
by apprich
Maytag Neptune washer MAH4000AWW

Started by Sue

Replies: 8
Views: 6205
Last post February 09, 2013, 07:41:01 AM
by def
Video: Whirlpool Washer Motor - Bad connection..

Started by AJ

Replies: 3
Views: 2102
Last post July 29, 2013, 06:32:05 PM
by AJ
Video: Whirlpool Made Direct Drive Washer Motor Coupler Replacement

Started by AJ

Replies: 18
Views: 39193
Last post May 18, 2010, 06:53:50 AM
by gimpyjones