HELP!!agin affinity washer E00 code

[williesanchez69]

Frigidaire ATF7000FS0 Washer. :embarassed:HELP this washer is given me a n error code E00,its not in the manuel,what does it mean?Ive replaced the main board,also it makes a humming noise as if ?the water pump? ,,please help guys im trying to get the low down on these new EQ,error 91 also came up said to check thw connections all seem makeing good contack,,,

[JWWebster]

Did you look in the cup for some junk in there?

[williesanchez69]

No i have not yet JW,,any idea on what the error code E00?? im looking in the manuels,nothing same as i have,Ive installed a new board,,uoch

[krazytech]

E00 is no code recorded

[krazytech]

E91 Selector LEDs do not light up

Check the wiring harness between the
control board & the interface board.

If defective, correct wiring problem.
If the harness is good and none of the LEDs light,
replace the interface board. If this does not correct
the problem, replace the control board.
Note: If only one of the LEDs will not light, replace
the interface board

[williesanchez69]

Yes SIR Krazytech i did get an E91,where is this UI board??is it the one under the main board a smaller board??

[JWWebster]

UI is user interface or touch pad am I right Kraz?

[krazytech]

Sure you are.

[krazytech]

I would make sure you have all the connections Good...some pins are easy to push out...check that all the led light up...