Author Topic: Maytag Neptune  (Read 1159 times)

Offline macemannj

  • VIP Member
  • Member Since: Mar 2011
  • Posts: 2
Maytag Neptune
« on: March 09, 2011, 09:26:14 PM »
When washer gets to rinse cycle it stops. I push start and it begins the1st rinse cycle. I then have to push start for the next 2 rinse cycles. After the 3rd it will go into the spin cycle ok. Any ideas. The board was replaced not to long ago because of spin issue.

Model MAH4000

Offline whirlpooltech

  • Technician
  • Member Since: Nov 2007
  • Posts: 1367
  • Country: us
  • 20 years of experience
Re: Maytag Neptune
« Reply #1 on: March 10, 2011, 02:42:43 PM »
The rinse cycle uses cold water. I would remove the cold water fill hose (shut the water off first) and check the screen in the water valve to make sure it's not plugged up. You may also have a screen in the end of the water hose too.

Offline macemannj

  • VIP Member
  • Member Since: Mar 2011
  • Posts: 2
Re: Maytag Neptune
« Reply #2 on: March 11, 2011, 05:12:43 PM »
Worked like a charm! Thanks so much! A fast, easy and inexpensive fix!!
Screen on the machine cold water inlet was crudded up. Cleaned it and BINGO.!

 

Maytag Neptune washer MAH4000AWW

Started by Sue

Replies: 8
Views: 9297
Last post February 09, 2013, 07:41:01 AM
by def
Maytag Neptune MAH4000AWW - No Spin.

Started by larry

Replies: 39
Views: 63069
Last post February 21, 2011, 01:22:14 PM
by bwhelan
Maytag Neptune MAH3000AWW Serial 19103060UB

Started by LarryC

Replies: 9
Views: 8277
Last post September 29, 2007, 09:49:12 PM
by AJ
Maytag Neptune MAH4000AWW Won't Drain Water / Smell

Started by mightymac

Replies: 22
Views: 25845
Last post February 15, 2013, 04:35:03 PM
by def
Maytag Neptune will not shut off.

Started by Boatsrule

Replies: 12
Views: 5695
Last post November 02, 2007, 10:15:35 PM
by sparky823
Maytag Neptune MAH4000AWW

Started by BOB V

Replies: 5
Views: 3787
Last post December 22, 2007, 06:36:49 AM
by AJ