Maytag Neptune

[macemannj]

When washer gets to rinse cycle it stops. I push start and it begins the1st rinse cycle. I then have to push start for the next 2 rinse cycles. After the 3rd it will go into the spin cycle ok. Any ideas. The board was replaced not to long ago because of spin issue.

Model MAH4000

[whirlpooltech]

The rinse cycle uses cold water. I would remove the cold water fill hose (shut the water off first) and check the screen in the water valve to make sure it's not plugged up. You may also have a screen in the end of the water hose too.

[macemannj]

Worked like a charm! Thanks so much! A fast, easy and inexpensive fix!!
Screen on the machine cold water inlet was crudded up. Cleaned it and BINGO.!