Author Topic: Electric Dryer LEQ2152ES0 not heating error code e56  (Read 16460 times)

Offline Soarer

  • VIP Member
  • Member Since: Feb 2011
  • Posts: 2
Re: Electric Dryer LEQ2152ES0 not heating error code e56
« Reply #10 on: February 22, 2011, 11:46:18 PM »
Using the flow chart for the problem the tests were ok for themmestor, control board, thermostat, open wire from terminal block.  The one that was not correct was the heating element.  It told us to remove power from the dryer, reconnect the black wire from rl2 and disconnect the plug from the drive motor.  restart the dryer and measure the voltage drop between yellow and white wire in the plug.  If 120 VAC defective motor if 0 defective heating element.  We got 1.3 VAC when tested.
Note the board test threw 240 VAC as it should have.

Hey Dee, did you get your issue resolved?  Did you have to replace the heating element?  If so, how much did it cost?

Offline AJ

  • Technician
  • Member Since: Jun 2007
  • Posts: 10368
  • Country: us
    • - Appliance Repair
Re: Electric Dryer LEQ2152ES0 not heating error code e56
« Reply #11 on: February 23, 2011, 12:06:45 AM »

If you need help with you dryer it would be best if you start a new topic.


LG Electric Dryer - doesn't turn off - no error code

Started by Josephine

Replies: 2
Views: 4680
Last post September 12, 2010, 03:32:24 PM
by jumptrout51
Electric Dryer - Error Code e5b

Started by Soarer

Replies: 1
Views: 6207
Last post February 23, 2011, 07:52:07 AM
by JWWebster
Whirlpool Steam Dryer F23 Error Code

Started by TechnicianBrian

Replies: 2
Views: 9423
Last post April 25, 2008, 08:25:02 PM
by TechnicianBrian
Error code 40 on Oasis Elite Dryer

Started by MWCmike

Replies: 3
Views: 6168
Last post September 16, 2008, 03:36:21 PM
by Repair-man
Replacing the Heating Element on a Kenmore Serise 70 Electric Dryer

Started by jracmm

Replies: 3
Views: 3981
Last post December 06, 2015, 07:50:18 AM
by dab147315
Frigidaire Front Load Dryer Error Code DR

Started by sharitac

Replies: 6
Views: 19441
Last post April 26, 2009, 09:07:40 AM
by JWWebster