Author Topic: Atlantis SOMETIMES needs a thump to get going  (Read 970 times)

Offline rollingthunder6

  • VIP Member
  • Member Since: Dec 2010
  • Posts: 5
Atlantis SOMETIMES needs a thump to get going
« on: December 10, 2010, 11:02:36 AM »
Maytag Atlantis washing machine SOMETIMES needs a thump to get going after filling up.

this question concerns a Maytag Atlantis washing machine, about 10 years old.
it has given excellent service so far ...  but every once in a while (once in a great while -- NOT every time)  the following occurs:  it fills up with water when started .... and then just sits there, doing nothing, 5, 10, 15 minutes, indefinitely .... .
if i give the machine a light thump on the lid -- or anywhere else --- it starts up and runs quite fine all the way thru.
what part might be responsible here, so that when this therapy of mine no longer works (hopefully sometime in the very remote future) i will know what to go looking for?
thanks in advance.

Offline MajorApp

  • Technician
  • Member Since: Feb 2008
  • Posts: 554
  • Country: us
Re: Atlantis SOMETIMES needs a thump to get going
« Reply #1 on: December 10, 2010, 11:15:29 AM »
 It sounds like a Lid Switch problem. Raise the top cover of the washer by depressing the spring clips with a stiff putty knife or similar tool and lift. The clips are about 3 inches in from both sides.

Offline AJ

  • Technician
    Administrator
  • Member Since: Jun 2007
  • Posts: 9435
  • Country: us
    • ApplianceJunk.com - Appliance Repair
Re: Atlantis SOMETIMES needs a thump to get going
« Reply #2 on: December 10, 2010, 01:10:43 PM »
Please post the model number for us, thanks.
Hope you find our site helpful.

 

Maytag Atlantis Model (MAV9501EWW) Will Not Start

Started by mngambas

Replies: 8
Views: 7045
Last post November 01, 2007, 11:42:28 AM
by mngambas
Atlantis squeak on end of spin cycle

Started by sdjjwilliams

Replies: 5
Views: 2879
Last post February 21, 2008, 11:14:11 AM
by sdjjwilliams
Maytag Atlantis Not Draining or Spinning

Started by dconsie

Replies: 11
Views: 10860
Last post June 28, 2008, 05:13:06 PM
by dconsie
Atlantis washer has oily looking spray on floor and around housing

Started by jcmartin1

Replies: 1
Views: 1684
Last post July 19, 2008, 08:53:28 AM
by Repair-man
Maytag Atlantis Washer, fills starts stops

Started by crazeddad

Replies: 10
Views: 5923
Last post August 17, 2008, 09:57:54 AM
by Repair-man
Melted Motor Pulley on Atlantis and Performa Models

Started by Repair-man

Replies: 5
Views: 4811
Last post October 22, 2008, 07:24:58 PM
by JWWebster