Unplug the harness from the motor and start up the machine. Have the meter set for AC voltage. Hunt for voltage in the quick plug. Use the service guide to your advantage. It give the steps.
Im not sure which plug is the quick plug. But I did test according to the tests.
I have voltage at
C2 Pin 5 to Pin 3 = 120 VAC
C2 Pin 6 to Pin 3 = 120 VAC with lid
At the C2 pin 6 to pin 3 it drops to 9VAC when I open the lid. Im guessing that it is operating properly
At C7 if i unplug it and I test VDC across the plug when I start a cycle I get nothing. Does this test need to be done in the hooked up position? I dont see how it will get any reading with it unplugged. Any help on this one?
C7 Pin 1 to Pin 2 = 135 VDC**
C7 Pin 1 to Pin 2 = 30 VDC**
I put the washer in field test mode to position 9 the "SP" spot and I get 9VDC at all of these pin connections
C4 Pin 5 to Pin 1 = 9 VDC*
C4 Pin 5 to Pin 2 = 9 VDC*
C4 Pin 5 to Pin 3 = 9 VDC*
C4 Pin 5 to Pin 4 = 9 VDC*