Author Topic: Whirlpool belt replacement  (Read 1259 times)

Offline brad

  • VIP Member
  • Member Since: Aug 2007
  • Posts: 194
Whirlpool belt replacement
« on: September 14, 2010, 05:00:56 PM »
I need help on how to change the dryer belt.How do you get into this thing?If you by chance have a service manual I would realy like to have one.Thank you.

Model GEW9868KL0

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8780
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: belt replacement
« Reply #1 on: September 14, 2010, 05:06:31 PM »
Use a putty knife on each end of the control to pop the spring clips. Then flip up the controls. Then it comes apart like this DOT dryer:
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL

Offline brad

  • VIP Member
  • Member Since: Aug 2007
  • Posts: 194
Re: belt replacement
« Reply #2 on: September 14, 2010, 07:38:00 PM »
Thank you so very much for the good info and video,I'm good to go.

 

Need help on belt replacement for Maytag dryer

Started by phlip2red

Replies: 6
Views: 9787
Last post May 31, 2008, 11:40:09 AM
by AJ
Dryer Belt replacement

Started by cdh3757

Replies: 3
Views: 5231
Last post June 24, 2008, 12:03:36 PM
by AJ
Maytag Performa Dryer Belt replacement

Started by feehar

Replies: 1
Views: 20393
Last post July 07, 2008, 11:10:47 PM
by Repair-man
Maytag Dryer step by step belt replacement instructions

Started by rmasten

Replies: 2
Views: 60878
Last post July 10, 2008, 07:07:55 AM
by Repair-man
belt replacement on maytag dryer LDE8414ACE

Started by markg

Replies: 2
Views: 7334
Last post October 15, 2008, 11:30:12 AM
by JWWebster
Broken Belt Whirlpool Dryer Question

Started by Trav

Replies: 1
Views: 1102
Last post March 11, 2009, 10:45:13 AM
by JWWebster