I hope someone can help me!
Let me give you some information. This an ice maker in a Whirlpool refrigerator. The problem is that the water valve wont open. The valve will work if I hook power straight to it, so the valve is good (I think).
The ice maker module will time thru if I activate it by jumping "T and H" I measure 120.5 volts between "N and L" throughout the entry cycle so I know that I am getting full power.
The problem is this. I ownly get 105 volt between "V and N" when the cycle is calling for water and that low voltage will not open the water valve, I can hear the water valve coil making a little noise.
Where is the voltage going?
Is is possible that the valve coil is partially bad?
Any help would be great