Washer. Can anyone tell me what may have caused this part of the Main Board
to over draw current and melt. I don't want to replace it without looking for the cause. The unit would not enter spin, seemed to drain fine. But groaned to try and agitate. Got a popcorn kernel out of the drain area after some work, pulled the drain pump and tested it, seems to work fine connected to 110 but had alot of Gray slimy grime in it. No error codes before the meltdown, and it won't turn on now. I have the main board ordered but, once again, would like to confirm the source of the problem. I attempted to attache a jpg of the main board.