The washer was working fine just intermittent spin, it would not spin everytime, maybe once out of 5 loads it would not spin on its own but if i put it back on spin cycle it would eventually spin. Now I can't get it to spin at all.
I am not an expert on this but it feels like the brakes are on.
I can replace the transmision for the cost of a service call but I want to make sure that's the problem.
I went back and checked the gear case and everything looks fine, the little spring that was mentioned earlier was still there the only thing that I was confused about was the plastic ring with teeth that went under the plastic gear with teeth that's on top of the gear case when you open it, the ring just goes on the bottom of the gear and nothing holds it in place if it is just spinning around how can it engage?